Channels Golf Club - will be affected by the new legislation?
Many of you about changing the rules of golf clubs in the quarries, with effect from 1 January 2010 I heard, but you know, if you're interested in? This brief article explains.
Extensive research has been conducted by R & A and the USGA, that the modern configuration "V" groove can produce the same amount of golfers from the rough in rotation, starting from the result showed the fairway.
In an attempt to place a premiumAccuracy of hard hits from the rough, the two bodies in a tongue and groove edge sharpness on the volume of all the clubs without a driver and putter with a loft to limit greater than or equal to 25 degrees. As a general rule, therefore, are subject to the results of a 5-iron and above. All existing restrictions remain grooves and surface roughness.
The new rules apply to all new models of clubs from January 1, 2010 must be considered, although the existing modelsthis time will still be allowed to be produced until the end of 2010.
This raises the question of "non-tour players just stick with models manufactured before January 1, 2010?" Unfortunately for them, the R & A and USGA too 'nice' for, because from that point will be a "Condition of Competition" at the highest professional levels, who have used the clubs under the new rules.
But as for me and you? Well, you'll be pleased to hearThere is too much for us, knowing why you're a top pro or amateur, in which concerns new rules are introduced in stages. 31 December 2009 and existing models at any time until December 31, 2010, to meet the current is at least 2024, and even then the period may be extended if the supervisory authorities in 2020.
So, no need to know that shelling out another small fortune on January 1, 2010 for a carefreebe set according to the iron, but be aware that if your money is burning a hole in your pocket and take a look on the shiny new model and then test only after that do not correspond to iron!
No comments:
Post a Comment